1313301 Tilt Nut for Delta Rockwell Table Saws - 3D printed

NOTE1: you cannot buy the OEM solid part for these anymore. the people selling the ones that look OEM are selling 3D printed parts that are printed to match the design of the injection molded part. this is a bad idea. my item here has been designed from scratch to improve the strength for printing, instead of using the shape of the original part. NOTE2: the saw needs to pivot freely, you will need to adjust the pivot bolt out a bit so it pivots freely without slop. being hard to tilt is why the OEM nut fails.
NOTE3: the C ring/clip that holds these on may have stretched over time. you should replace it with the nut, or at the very minimum bend it back so it fits snugly. 
NOTE4: this is made of the strongest filament available, but that filament is sensitive to excessive heat. don't expose this part to high heat. for instance, don't put it in your attic or in a hot car.
Will fit on the following Delta Rockwell Table Saws:

    36-380
    36-600
    36-610
    36-670
    TS300
    TS350

this item is 3D printed but should be as strong as the original injected molded part, and stronger than the 3D printed ones that are shaped like the original part.